Show\Hide Navigation Product Description: Appendix
Up Down Back Forwards Print Synch call us

IP406 V2 Control Unit (No longer sold)

The IP406 V2 control unit is a stackable unit with an optional 19" rack mounting kit. The IP406 V2 includes:

Eight Digital Station (DS) ports for supported 2400, 4400, 5400, 6400 and T3 Series phones plus 3810 wireless (US) phones.
Two Analog telephone ports.
Two Wire
DTMF signaling (No rotary or Loop Disconnect)
Timed Break Recall (No Earth Recall)
Caller ID capable – a variety of standards, see later
MWI capable – 82.5V and Line Reversal
Eight 10/100 Mbps LAN Switched ports (Layer-2, unmanaged).
Support for optional embedded voicemail/auto-attendant (Compact Flash card)
9-pin DTE Port (for maintenance or Feature Key connection for application licensing).
X.21/V35 WAN interface.
Support for up to 6 IP Office Expansion Modules:
Phone modules (8, 16, 30)
Digital Station modules (16, 30)
Analog Trunk Module 16
So8 module
External O/P socket supporting two relay on/off switch ports, e.g. for door entry systems.
Audio input port for external music on hold source.
Two trunk interface card slots for analog, BRI, PRI (T1, E1) or CAS (E1R2)
Internal socket for IP Telephony expansion – voice compression modules (from 4 to 30 channels)
Internal socket for internal modem (2 or 12) for Remote Access Services
50 Data channels
Up to 20 VoiceMail Pro ports

ip406 v2 front annotated

ip406 v2 rear annotated

Expansion Modules

Through support of up to six external Expansion Modules, IP406 can be enhanced to support a mixture of analog, digital or IP phones, to maximum of 190 phones in any combination.

If additional analog trunks are required, these can be aggregated in groups of 16 on each analog expansion module

Data Channels

A Data Channel is used for Remote Access (RAS), Internet Access, and Voicemail sessions. A data channel is an internal signaling resource used whenever a call is made from the IP network to an exchange line (Central Office). For example, four people surfing the Internet will use a single data channel since they all share the same line to the ISP. Two people remotely accessing the Office LAN from home will use two data channels since they have dialed in on separate lines. IP extensions do not use data channels. Data channels are used for voicemail connections with a maximum of 20 available for VoiceMail Pro on an IP406 V2.

Modems and Voice Compression modules

You can add additional hardware to the IP406 system to add one modem card (2 or 12 V.90 modems) and 1 Voice Compression Module (VCM). The VCM supports from 4 to 30 simultaneous Voice over IP sessions and is used for either providing networking between sites over a Wide Area Network or supporting IP Telephones and Soft phones.

© 2010 AVAYA
15-601041 Issue 20.f.-
18:15, 25 February 2010
(ip406_v2_control_unit.htm)

Performance figures, data and operation quoted in this document are typical and must be specifically confirmed in writing by Avaya before they become applicable to any particular order or contract. The company reserves the right to make alterations or amendments at its own discretion. The publication of information in this document does not imply freedom from patent or any other protective rights of Avaya or others.

All trademarks identified by (R) or TM are registered trademarks or trademarks respectively of Avaya Inc. All other trademarks are the property of their respective owners.

Last Modified: 29/06/2009